03-10-2011 04:48 PM - edited 03-21-2019 03:47 AM
Presently the outbound CLI for SIP trunking is the "Pilot Number" only and does not allow DDI's to make calls via the SIP trunk, you allow inbound DDI mappings but a number of our customers want the ability to present their individual DDI CLI's, Is this part of the roadmap, and if so when do you think it is due ?
Regards
Phil Moore
03-11-2011 04:16 AM
Hi Phil;
Thanks for your question. I can say that it is indeed included in the roadmap, planned for release 2.2 targetting (but not committed) for end of the calendar year. Stay tuned.
Regards
Alberto
03-13-2011 10:57 AM
Once again thank you for the response, for us this is commonly used setup in our part of the world so I hope Cisco can push this particular feature up the timetable a bit if possible.
Regards
Phil Moore
04-16-2011 09:23 AM
Yes,
Please Alberto - please can you push this one a little ? The cli per seat issue came up again yesterday with another customer.
As far we we are converned - VoIP.co.uk (Service provider) - we just need to see the SIP From header be different per extension, it could be the extension number or name. We don't need anything more than this as we can re-write everything from our side
thanks
Adam
06-27-2011 12:52 PM
Hi Team,
Just wanting to see if any updates around outbound CLI presenation for DDI's , Cisco is launching this product in New Zealand this week and the for many customers this is the one big drawback at present, so just want to see if this still on the roadmap and when it is likely to be added.
Regards
Phil Moore
06-27-2011 12:56 PM
Hi Phil,
This is part of the 2.1 firmware release due out later this summer.
Thanks,
Chris
06-27-2011 06:30 PM
Hi Chris,
Do you mean your Summer our Winter??
Both Australian and NZ are going through winter right now it will help with time lines if you can confirm this.
Cheers,
David.
06-28-2011 07:39 AM
David,
Ah yes, would like to enjoy your winter once again. Watch for the release in the next 2 months.
Chris
06-28-2011 01:02 PM
Thanks Chris, that is good news ... I can wait 2 months ... just
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide