08-12-2009 08:18 AM - last edited on 03-25-2019 10:40 PM by ciscomoderator
We have roughly 40 7940/7960's and 2 7921's that all display the correct time. However, we have 4 7911's that are all 4 hours ahead of the actual time. If you show clock, this is the output:
UC520#show clock
11:14:26.052 EDT Wed Aug 12 2009
But the 4 7911's all display 3:14, in CCA the phones are pulling the correct phone load. Ideas?
Thanks,
Jeremy
08-12-2009 08:32 AM
Can you verify that the command "type 7911" is under the ephones associated with your 7911's? Also, what is the clock summertime configuration that you have in the show run, if any?
Thanks,
Marcos
08-12-2009 08:40 AM
Marcos,
This is for the ephone near me, but they all basically look the same.
ephone 40
device-security-mode none
video
mac-address 0024.C443.CF40
max-calls-per-button 2
username "sroom" password 1234
paging-dn 1
type 7911
button 1:45
We are on the East Coast, so that looks correct.
clock timezone EDT -5
clock summer-time EDT recurring
Thanks,
Jeremy
08-12-2009 08:46 AM
Under telephony-service, do you have a timezone command?
08-12-2009 09:11 AM
Thanks Steven,
Once into the telephony-service I am not positive on the syntax required to give me that output. I have tried 'show' timezone, but that is an invalid command in this section. How would I be able to display the information?
Thanks,
Jeremy
08-13-2009 07:23 AM
You could do a
show run | inc time
and it will display the output I am looking for.
08-12-2009 08:23 PM
"show telephony-service" show the telephony service..
Then go to CLI... and go to enable mode.
type
telephone-service
no create cnf-files
create cnf-files
See if that helps..
02-03-2010 09:10 AM
So it has been a while, but I am back on this now. And as it stands, the 4-7911's are now all off 5 hours. Current local time is 12:09PM EST, and the 7911's all display 5:10PM. Per the last post, here is the info Steve requested.
UC520#show run | inc time
service timestamps debug datetime msec localtime
service timestamps log datetime msec localtime
clock timezone EDT -5
clock summer-time EDT recurring
I also ran a:
UC520#show telephony-service
CONFIG (Version=7.1)
timezone 0 Greenwich Standard Time
The timezone definitely explains the 5 hour difference, but: A.) How do I change it, and B.) Why is it only affecting the 7911's and not the rest of the phones. Do I also need to setup the Summer-Time in the Telephony-Service?
Any ideas would be greatly appreciated.
Jeremy
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide