03-25-2011 09:08 AM - edited 03-21-2019 03:51 AM
Hi I have instaled the system spa9000/sp400 and a WRV210 Wireless-G VPN Router and
recently I instaled another WRV210 Wireless-G VPN Router in another location of the same company
I configured the VPN between this two devices the question is, Can I install a phone in one site and
can it access to the spa9000/spa400 in the other side through the VPN?
03-25-2011 09:25 AM
Hi Azariel;
Yes, if the phone is on the same LAN segment as the SPA9000. You need though to connect it first the phone on the local LAN to get configuration and register, then move the phone to the remote site, as multicast traffic will not pass.
Regards;
Alberto
03-25-2011 10:19 AM
Thanks for the answer, I have another question, yesterday I have a report about a problem with
the phone that ara instaled with this system, spa502G and spa942 well, 2 of the spa942 and one
of the spa502G power off and then power on but not at the same time and the other phone didn`t
power off, this problem have occured three times the firmware is the lates, all the devices (switch, spa9000/spa400)
are in a UPS....
03-27-2011 06:20 PM
Hello Azerial,
If all of these phones are connected to the UPS along with other devices and these are the only devices that seem to be powering off and on automatically and not manually. Then it's possible that you could have a hardware issue with these devices. If a firmware upgrade has just been performed on these devices, then it's also possible that the firmware upgrade didn't install all the way correctly. I would reset these devices back to factory default and upload the firmware if a firmware upgrade has recently been performed. If not and the problem persist. You may need to call into our office and get a support ticket started for these phones.
Fredrick A Wofford
Network Support Engineer
Cisco Small Business Support
Contact# 1-866-606-1866 if calling within the United States.
03-31-2011 12:52 PM
Hi Alberto, well I have another question, one phone was registered in the local network and then it was moved to the remote site
as you explain, the phone at the remote site display de name and the extension and I can see the phone registered in the
SPA9000 in the PBX status, but when I want to call from the remote site to an extension in the other office it isn`t possible
and when I press the speaker it doesn`t make any sound the model of the phone is SPA502G firmware 7.4.8, the vpn is enable
and I can see the phone registered in the SPA9000, thanks for you help.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide