uc500 and cyberdata paging gateway

[Barry Hunsinger]

I am setting up a Cyberdata sip endpoint for paging. I have successfully installed the cyberdata sip intercom on other systems (uc540) and they work well. I am not having much success with the amp. I have tried many configurations in both the uc540 cli and the cyberdata sip paging gateway.. I am including the latest config and the latest debugs.

Cyberdata was a help in the beginning but they are lost as well. When I dial the extension I get a fast busy. No matter how I configure it I get a fast busy when I dial the extension. The unit does show that it is registered with the sip server. It could be an acl issue, but I don’t want to change the acl’s until I know for sure.

[pennautomotive]

I have been experienceing the same issue. I have been unable to get a CyberData intercom to sucessfully resigter with our UC560. The weird thing is the intercom has no trouble calling out. I did find a work around though. I set up a dial peer to point all calls to that extention to the IP address of the CyberData intercom. I'm sure it's not the best way but for now it works.

[pennautomotive]

Also it is worth mentioning that for me the intercom itself would not show up as registered through its web interface.

[Barry Hunsinger]

this is a paging gateway for loudspeakers. The intercoms that I have configured are working fine. if you like to see the settings I used let me know. When someone presses the call button I have it ringing to a call blast group, when they answer they get a two way conversation and the when they press a button (5) the door opens. I used a vlan1 address on the intercom, but in the settings I used in cli I used the vlan100 address of the sip server.It does show "registered with sip server" thanks

Barry Hunsinger

SBI, LLC

Small Business Integration, LLC

908-265-2006 cell

908-753-0420 fax

barry@cmf.net

barry@sbi-nj.com

Cisco Select Certified

Cisco Small Business Communication Specialist

www.sbi-nj.com

>>> pennautomotive <supportforums-donotreply@supportforums.cisco.com> 5/25/2012 12:42 PM >>>

Home ( https://supportforums.cisco.com/index.jspa )

Re: uc500 and cyberdata paging gateway created by pennautomotive ( https://supportforums.cisco.com/people/pennautomotive ) in SBCS - UC500 - View the full discussion ( https://supportforums.cisco.com/message/3644878#3644878 )

Also is worth mentioning that for me the intercom itself would not show up as registered through its web interface.

Reply to this message by going to Home ( https://supportforums.cisco.com/message/3644878#3644878 )

Start a new discussion in SBCS - UC500 at Home ( https://supportforums.cisco.com/choose-container!input.jspa?contentType=1&containerType=14&container=2195 )

Message was edited by: Barry Hunsinger The calls to the cyberdata amp are trying to go out to our sip provider, and of course the call fails with a fast busy. how do I keep the call inside and get it to the amp.Is it a dial peer issue ?

[Paul Santabarbara]

Barry, I am having the same issues as above.

I am using a CyberData SIP Paging Adapter.  I configured it as such:

Device name: Page

Password: page

Static IP: 10.1.1.5 mask 255.255.255.0

I will attach a Show Run.

I gave the Adapter 1212 to dial to.

Can you tell me what I am missing?

Thank you, PAul

[jacobnakhla]

Did you ever get this running. I have a cyberdata sip paging amplifier and not having it register either