02-09-2018 07:43 AM - edited 03-21-2019 09:10 AM
We have two UC540s. Both devices are configured with identical dial-peers for voice mail.
When a call from UC540-A is made to a DN on UC540-B, if it goes unanswered and is set to forward to the voice mail pilot, the call is directed to the dial-peer for the voice mail pilot on the originating UC540-A.
Everything else appears to be working fine. It's only calls that originate on one UC540, are destined for the other UC540, and then call-forwarded to voice mail.
When call-forwarding is setup on a DN, does it normally use the dial-peers of the originating calling party's UC540 instead of the dial-peers on the UC540 of the DN that is forwarding?
No other numbers overlap except the voice mail pilot.
Thanks!
02-09-2018 07:53 AM
02-09-2018 08:31 AM
The protocol specified on the dial-peers between the two UC540s is cisco, not sipv2.
02-09-2018 08:43 AM
02-09-2018 09:22 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide