Voice Systems and Accessories - Small Business

Upgrade your communication system with our Voice Systems and Accessories, perfect for small businesses.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

Hi.Are we allowed to edit phone dictionaries for fixing cyrillic numpad?We found that in 504/525 there was degrade in numpad translation.Lots of symbols missing. Inside of xml dictionaries we found keymap section 525:<!-- #############  KEYMAP ######...

Hi,I'm a total newbie in using Cisco phones, but I've noticed that when I reject a call on my SPA504G, that call is not a "lost" one (it would be in almost every mobile phone firmware, for example), and not a "received" one too (!).So, rejecting a ca...

I have an SPA232 with a couple of SPA302 handsets.  I want to add the blind transfer and remove the regular transfer.I found the setting (Blind Attn-Xfer Enable) in the 232's web admin and enabled it.  After doing a firmware update the handsets picke...

c duff by Level 1
  • 377 Views
  • 0 replies
  • 0 Helpful votes

Does anyone have any experience with configuring the SPA 3102 with the Ooma Telo devise. I have been around and around on this with no luck. I have been able to get into my 3102 ip address fine, but I need a proxy server to configure the 3102 with my...

Hello, we have 10 users in our network and we have 4 FXO port and lines connected to them, we would like to implement this on UC540 below; 2 users will have access to FXO port 13 users will have access to FXO port 23 users will have access to FXO por...

rammany19 by Level 1
  • 329 Views
  • 0 replies
  • 0 Helpful votes

I have 2 x Cisco 7925G phones that are running 1.4.1 SR1.  If I upgrade the phones by USB to 1.4.5, will I run into any issues.  I can't upgrade the firmware through the UC520 since its newer than the software pack.  I guess the same question would a...

ReidJones by Level 1
  • 1470 Views
  • 7 replies
  • 0 Helpful votes

I've been trying and trying to create a custom ringtone for my Cisco 303SPA but I haven't been able to!According to this FAQ the Cisco 303SPA ringtone format is G.726-32, and Ring Tone Suffix is .726. However when I try to create the ringtone, it doe...

Santicity by Level 1
  • 686 Views
  • 0 replies
  • 0 Helpful votes