04-24-2011 03:35 PM - edited 03-21-2019 03:59 AM
Update firmware UC320 have big problem !!!
I got new UC320W. when I connected it to internet, the new firmware was shown in WebUI.Then i accepted to upgrade, after it was upgraded to 20% it show not enough memory and crash. after that I can't access to WebUI its show httpd service is close but now i can access via telnet but i don't known user and password becuase i use the same password from WebUI but can't access to UC320 with telnet. How i can fix it ?
07-01-2013 07:26 AM
I'm very disappointed.
Cisco deceives her customers and partners in this way.
07-01-2013 07:39 AM
Hi Efim,
Cisco Small Business Support team can help you to unlock the unit. Please contact them to get the user name and password.
Best regards,
Wendy Yang
07-10-2013 07:27 AM
Hi Wenjin,
I too have a Cisco UC 320W which we bough long ago from local partner, but we did not used it for long. Now we try to use it only to see that its not supported in our region (Saudi Arabia) I tried to talk to support team and they said device is out of support by couple of months. Is it any way i can engage them to give me the password for telnet so that i can figure out if i can add/remove dial plans.
JAwad
07-10-2013 07:41 AM
Hello Ahmed,
Do you have a Support Contract on the Box? If there is no support contract, you may not get any support on an out of warranty box. You may want to consider getting a support contract and then contact SBSC.
http://www.cisco.com/cisco/web/solutions/small_business/shop/index.html-tab-Services
Hope this helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide