04-24-2013 03:23 PM - edited 03-21-2019 07:16 AM
I have connected my UC540 latest software pack to a FIOS Box. i'm only getting half the speed.
Can someone post the steps on CLI to make the WAN interface full duplex please?
04-25-2013 01:44 AM
hi there,
this should do the trick
!
conf t
!
interface GigabitEthernet0/0
speed 100
duplex full
!
end
!
wr mem
!
04-25-2013 08:37 AM
It would be `interface FastEthernet0/0` for a UC540 actually.
In any case, I believe they are set to "auto" by default... which should have chosen full duplex.
From his description it sounds more likely that he has a throughput problem than a half-duplex issue.
How fast is your FIOS connection? The UC500's aren't really designed for very high speed WANs.
The other thing to check would be traffic shaping settings, if misconfiged, they could certainly limit your speed.
Dan
Please rate useful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide