How can we setup our system to show the call information for the line the we are monitoring. I have a 7975 that is monitoring several lines. I can tell when someone is on the phone (button red) but I have no idea who they are talking to.
Noticed on the Smart CallConnector that there is a field for the Number and Caller Name, but they are currently unpopulated.
Where can I setup more information for these monitored lines?
I think the number fields are supposed to be populated.
Check your software version and config, if all OK, report problem to Cisco via SBCS possibly.
Ah... That sounds like what we need. Since you cannot do this in the CCA, can you tell me which part of the UC560 we need to telnet into for this change?
Would it be the CallManager I guess?
max 200 (or whatever number)
make sure you have ephone-dn-tempalte for any ephone-dn
after that, when you configure blf-speed-dial, the icon will change from keypad, to phone over keypad.
Thanks for the nice rating and good luck!
Do all ephone-dn automatically have a templeate? I cannot find which template is applied on our UC560 to the phones that I need - which is all of them. Perhaps we do not have a template?