09-13-2012 09:53 AM - edited 03-21-2019 06:17 AM
Hi,
We are installing a eval version of UCC operator in standalone deployment.
Trouble is we can't even log into the application to see how it works or test it.
We run through the installation process and it reboots the PC. When we try to login it fails with either bad username or password, or the server.
As this can't be a server issue as its pointing to itself (Standalone), it must be a username and password problem.
We have tried every user and pass it could be - IP phone user and pass, local PC user and pass, Admin user and pass but nothing is working.
Has anyone had this same problem?
Slightly embarrassing to have to post such a question but its causing some pain......it cannot be that difficult!
We cannot log into the config manager either. Is there a default username and password for this?
Any help appreciated.
Oli
Solved! Go to Solution.
09-16-2012 12:18 AM
Hi,
You should be able to login to the new install using the username cisco and password cisco.
Thank you,
Jason Nickle
09-16-2012 12:18 AM
Hi,
You should be able to login to the new install using the username cisco and password cisco.
Thank you,
Jason Nickle
09-17-2012 01:57 AM
Hi Jason,
Yes, we discovered this now. Fairly embarrassed but I don't recall seeing this anywhere in the documentation.
Hence why this wasn't tested.
Thanks for your reply
Oli
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide