VPN

One of our ASA5505 can not ping the gateway today.But when I use a notepad , using the same IPs, it can ping the gateway !!!It is so strange, the ASA5505 was working ok before until today.Is there anyting I can do to check whether the ASA is ok ?

Has anybody tried installing Anyconnect onto Mac Hardware loaded with 64-bit windows?I'm getting repeated errors in the application log "[libcsd][error]acquired mutex."Here are some others that may be related:The driver \Driver\vpnva failed to load f...

We would like to monitor a site-to-site ipsec VPN tunnel on ASA 5510. It seems a Cisco ASA OID need to be configured on the monitoring system. Where do I find this OID? Thank you.

I've seen a bunch of discussions on the untrusted server cert error with self signed certs.  But I have a valid wildcard that I use on my ASA.  How do I make that work with out the untrusted server cert error?TIAScott                  

Hi all,We are using an ASA 5540 running 9.1.1 code.  I am currently testing the anyconect client that is authenticating using a Windows 2008 radius server, and when users connect using anyconnect, they see a connection profile drop-down list.  There ...

Hiiam facing issue with site to site VPN on cisco 881 with ADSL connection. ADSL settings are on ISP modem and modem is connected to cisco 881 fa4 interface, will get the dhcp ip address (192.168.1.101) from ISP modem. i have onfigured site to site v...

Hi.One of our clients has the following scenario...ASA 5510 FW v7.2 at head office800 series routers at remote offices.All remote sites of establish a Site to Site IPSec vpn to head office ASA.They want to increase the speed over the VPN's so they ha...

Error 1609. An error occurred while applying security setting. Everyone is not a valid user or group. This could be a problem with package, or a problem connection to a domain controller on the network. Check you network connection and click retry, o...

Hi all,I have c3725 router that have two WAN interfaces, both of which I want to serve VPN clients. However, I have only one default route, say for WAN1, so how can I accept client requests on WAN2.ps: I use vpdn and pptp, and I'm a newbie to Cisco r...

Our customer has a VPN tunnel that requires traffic on our side to be NATted to a different subnet to avoid a subnet conflict with a subnet on the other side of the tunnel. The tunnel is up and working for the most part. RDP and ping traffic works wi...

Has anyone come across this (bug, I believe) in their ASA logs for site-to-site?Apr 23 16:15:24 iac-jtl-mgmt Apr 23 2013 16:15:43: %ASA-4-113019: Group = <IPSec peer IP>, Username = <IPSec peer IP>, IP = <Unknown IP>, Session disconnected. Session Ty...

I tried to setup an ACL on the outside interface, but it still seems that the RA VPN is open to all hosts. How can this be limited?