VPN

ASA 8.2+ documentation tells us to use the RADIUS VSA 3076\25(Group-Policy) to assign the VPN user group policy.This used to be done with IETF RADIUS CLASS 25.My ASA recognises this attribute as Group-Policy when sent by RADIUS but it completely igno...

Hi there,We have configured an cisco 2800 for vpn clients. The weird thing is that after some time (not specific time interval and no idle connection) asks for re-authentication. Some times after re-authenticating session disconnects. Any ideas?

Hello All,Could anyone please help me in knowing the replacement model for VPN concentrator 3020, where the new device should support minimum 250 simultaneously PPTP connections for external PDA connections.Thanks in advance.

Hi all,I have the following problem.Is installed a software(GPS Software for Bikeracing).Problem: The software only starts up when VPN Client is connected.If VPN is not connected I cant start the software.Any idea?

First of all, please be gentle I haven't worked with Cisco devices before (yepp, another one of those) but I am getting there. I have replaced my silly Draytek router now with a Cisco877 and it works perfectly fine. But the whole networking side of t...

I can connect to a 877 router via SSL, however when I click on “Start” for Tunnel connection a separate window is opened with a “Website not found 404 error”.  What is causing this?

I have an DMVPN Phase 2 network.  What is the impact to established Spoke-Spoke connections if the hub fails?  Does the choice of routing protocol impact the behaviour?  Does this change with Phase 3? 

Hi,We need to configure SSL VPN on a 2821 router just to provide VPN connection (with ability to create some “enhanced” access restriction policies) to some of our mobile employees. This router is currently our VOICE gateway as well. The IOS version ...

*May 23 13:00:49.791: EZVPN(backup): *** Logic Error ****May 23 13:00:49.791: EZVPN(backup): Current State: NO_CHANGE*May 23 13:00:49.791: EZVPN(backup): Event: RESET*May 23 13:00:49.791: EZVPN(backup): Resetting the EZVPN state machine to recover*Ma...

In my Cisco PIX-515E Version 6.3(5), I have a IPSec VPN tunnel and also to the same firewall home users connect through VPN client. I am unable to find a solution that allows my home users to connect to office network and again access the remote netw...

When the phone is connected through the VPN will the PC connected to the phone be on the inside as well?

I have a working site2site between 2 ASA5520 8.2(3)I want side A to be able telnet\ssh to side B's ASAusing the telnet command would do it or should I also add an access-list?

Hi guysive recently setup a EazyVPN on a cisco 3g router with a ASA5520.  the tunnel comes up ok and the remote users can browse the net.The problem is accessing the lan behind the ASA.  when you do a show cry ipsec sa at the ASA you get the followin...

Hello Guys,Can you please check my below site to site VPN config and suggest me as i am not not able to bring up the VPN using show crypto isakmp sa.                                                                                           Fa0/0     ...

I seem to be having issues with getting IPSEC to run when I use  NAT, with no NAT this works perfectly fine but with NAT, the ACL to the Crypto Map does not get hit. I am currently trying to test for a new deployment, as we connect to many 3rd partie...