VPN

Now, our VPN users connecting  whith Cisco VPN CLient to interface outside.interface GigabitEthernet0/0 nameif outside security-level 0 ip address 200.200.200.2 255.255.255.128 standby 200.200.200.3 ospf cost 10But we gonna use new IP addresses, so ...

Hi all,while configuring the ASA 5510 for VPN I encountered this errorThis showed after I enter this commandciscoasa(config-pmap-c)# inspect dns migrated_dns_map_1ERROR: DNS policy-map migrated_dns_map_1 not configuredWhat is the meaning of this erro...

We are running Cisco VPN client 5.0.07.  When we connect to the internet by using the Verizon Broadband wireless card, the VPN client would disconnect after 2 minutes with split-tunnel.  However, if we setup full tunnel, the VPN client would not disc...

Hi, I need to disable NAT on a Easy VPN 2801 hardware client (Network Extension Mode).I successfully disable NAT for traffic traveling in to the tunnel, but I couldn't disable NAT for the split tunnel traffic. NAT still translating traffic with the o...

hello, I have configured a firewall ezvpn a handle 5520 and a router 881. this  worked all right, my question is: Is there any way to automate the  connection of the router with the firewall so we would not always be  entering the command "crypto ip...

My IT department is requiring an upgrade of the Cisco AnyConnect Client.  I am not sure what version I had before, but I believe it was a 3.x version.  That version was working fine.  However, whenever I try to install the Cisco AnyConnect version 2....

Hi I have a problem with ipsec tunel on ASAPhase I is OKbut phase II is weardlet's say local ip is 200.4.250.10local host 192.168.0.1/32remote net 172.20.0.0/16peer ip is 100.30.20.10-----the output of show crypto ipsec sa gives:local ident (addr/mas...

Hi All, I've configured ssl/web VPN on a cisco 1941 however when I try to connect no page displays.. It simply just times out... We are running a Cisco 1941 + Security... IOS =  Version 15.0(1)M2    (c1900-universalk9-mz.SPA.150-1.M2.bin)Running conf...

Hi,I have setup both webvpn and anyconnect for someone on an ASA5510 8.0(2). There a file bookmarks and an OWA( outlook web access) link configured.This all works fine with firefox and Internet explorer, however when using Safari things go horribly w...

Hello everyone, I’m trying to connect using the VPN client version 5.0.07.0290 (installed on Windows 7 x64) using a connection entry using a certificate authentication. The profile host is correct, also the certificate is correct. However I cannot es...

Hi,We are having problems with Anyconnect client after upgrading from 2.4.x to 2.5.0217, but only on some computers.We've made tests on some computers and it works fine, but on two PC's there is a problem which we can see on ASA like this:4|Jul 22 20...

Hello to everybodyMy System:Win 7 x64 ProfessionalCisco Anyconnect VPN Client 2.4.1012Group: ssl_GrpMy Problem is:If the Anyconnect Client is connected to our Uniiversity network (For Internetaccess), it will not be possible to syncronise the PDA via...