VPN

Hi all, I'm very new for ASA. My current company wat to setup VPN to user to access internal. So now I'm trying to setup VPNauthenticate with my NPS server. The VPN can connect and acess outside network but cannot access internal network. Would you p...

Hi,i'm just a beginner in cisco ios, and i've just configured a 867 for wan access via adsl. Now i'm trying to connect to the 867 via a ipsec vpn with a remote client (i.e. a macbook) , and it works ok. But when connected, i can't ping devices nor co...

Hello All, I'm in need of some assistance as I'm going around in circles and to be honest I cant work it out.   I have a client who for the past 4yrs has 2 sites with buls standard ADSL+ at each location and an IPsec Gre tunnel between the 2.  The c...

I have a site-to-site tunnel up between two locations (non-ASA initiator, ASA responder). The tunnel will come up but not stay up. I'm 95% sure I have an issue in my crypto maps but I'm at a loss. The initiator's configuration is mostly hard coded. F...

i repalced old cisco router 2811 with new one 2921 , all works except crypto map VPNsrouters can ping each other , ACLs are not applied to outbound interfaces show crypto isakmp sa is empty after i make same configuration on a new router 2921 configc...

Hi I have setup AnyConnect VPN and all works fine apart from the warning messages appearing about the server being Untrusted.I am not too good with certificates so any help will be much appreciated. When I open anyconnect client and click connect, th...

Hi, What is the best way to limit the ra vpn to domain computers.  We were looking to do a combination of certificate validation and user authentication. We could push out the certificate via group policy.  I am running into issues and the error in...

Hi All,  I hope someone can help, I am trying to configure the cisco vpn client access to our Cisco 887VA-W, it doesnt use the dialer interface and for its public IP access uses 1 to 1 NAT from our watchguard router. The VPN client seems to be able t...

Our company is seeking to setup two sites to connect to Microsoft's Azure cloud.  Microsoft has not had and for that matter still does not have the any documentation on this done.  They had some information and now this has ben deleted what they did ...

Hi, I have the following  setup , tunnel (remotesec )is up but host cannot access group-policy VPN_GPO internalgroup-policy VPN_GPO attributes dns-server value 192.168.10.10 vpn-tunnel-protocol ikev1 split-tunnel-policy tunnelspecified split-tunne...

I'm looking at needing to increase the volume-based lifetime SA on ipsec tunnels between an ASA running 8.4 and an ASR running 15 something. The ASR side has the ability to turn off the volume sa option, but I can't on the ASA at this code. What woul...

Hello  Team, can  you  please  help  me  to understand, if the  Site-A  VPN device is  Internat  facing and  Site-B VPN Device is  Behind another Firewall . The outside interface of the Site-B VPN device is NAT with  Firewall.  Can the Site 2 site V...

Is there any way to change the language on the AnyConnect client?The client prompts for UsernamePasscodeSecond Password I want to change what these say to Username PasswordRSA PasscodeAny help would be greatly appreciated. I can find how to change re...