09-21-2019 03:55 AM
Hi,
I set up DVTI in EVE with 2 routers.
HUB------SPOKE.
Virtual-template is not showing up/down. Instead of up/up.
Checked Phase1 and Phase2 parameters but not sure where I made a mistake.
Attached diagram and configuration.
Please take a look.
09-21-2019 04:33 AM
Hi,
Use Loopback0 as the ip unnumbered interface on both ends to establish a tunnel, you may need to define the tunnel source on the Hub's tunnel template aswell.
09-21-2019 10:46 AM
I tried using loopback and it worked. Also, it worked with my original configuration after I did a "clear crypto session".
Thanks.
09-21-2019 11:26 AM - edited 09-21-2019 03:55 PM
If you peer the tunnels using the physical interface (Eth0/0) you will find that you can route traffic from the spoke over the Tunnel0 interface (if you create a static route), but on the hub when using a DVTI as the interface is dynamically created you cannot specify a destination. Normally you'd use loopbacks when using DVTI and then run a routing protocol, forming an adjacency between the loopbacks - routing the traffic over the encrypted tunnel.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: