PRI to BRI connection between h.o and remote branch

[binoyjosephstanly]

Dear all,

in my H.O i have a 2801 with VWIC2-1MFT E1/T1 and i have an E1 leased connection which is 2.048Mb, and at the branch side

i have 1841 and ISDN BRI card and my ISDN BRI connection is ready at remote branch

i need to connect between these 2 offices, can anybody give a sample configuration, i will be connecting 10 remote offices in future.

i will rate all the posts.

regards

BInoy

[JamesLuther]

Hi,

Please find an attached example config for a central site where

10.0.0.0/24 is the central site

10.0.1.0/24 is site 1

10.0.2.0/24 is site 2

The transits between the sites are 10.99.99.x/30

The ISDN config is for a UK E1 PRI.

Not sure if this exactly what you need but I hope it helps

Regards

[binoyjosephstanly]

hi james,

thank you for your reply.

i have couple of doubts.as i have explained in my first post, i have a leased line which is E1 and for sure i can channelize it. suppose site 1 using BRI so the site 1 router need to dial into my H.Q correct me if i'm wrong?

as it is a leased line at H.Q i will not be getting seperate no's for PRI channels. i'm really confused it will be great if you can provie your views.