Show traffic load on site-to-site

[Tommy Svensson]

Hi.

I'm interested in how much traffic goes through my site-to-site tunnels. I have about 5 tunnels set up and I can only see the load on each interface with "sh interface giga 0/0" and beside the "30 second input rate". Is there any way of seeing this for my site-to-site tunnels aswell? Couldn't find anything about it.

Kind regards, Tommy

[Michal Dulovic]

I am not aware of any specific command to show some more complex bandwidth utilization stats or something. You can also change the input rate interval if that will help you.

Maybe you can try to poll your device using snmp and get traffic stats with it. Just be sure to set up a granularity according your needs. Typically you would not record microbursts with snmp.