I have 2 1gb wan ethernet pipes coming into our new building. Our ISP has brought both connections in on the same (vlan) on their end (non internet). I basically need this setup so I get the best performance out of the 2 1gb connections. The provider said they won't port channel to me. So if I use the below configuration how will it treat the 2 switchport wan connections. Will spanning tree block one port and forward out the other. I am trying to figure out how to load-balance the 2 wan connections through a DMVPN SPA VPN (This site would be the hub of a DMVPN environment). The 2 Gigabit interfaces would be my wan connections. (G1/2, G1/1). Will a bridge group work with the spa vpn adapter. I know they have alot of limitations.
Any suggestions???
vlan 101
name Centurylink_connection_layer2
exit
interface GigabitEthernet1/2
desc **centurylink link 1 1gb**
! switch outside port
switchport
switchport access vlan 101
switchport mode access
!
interface GigabitEthernet1/1
desc **centurylink link 2 1gb**
! switch outside port
switchport
switchport access vlan 101
switchport mode access
!
interface Vlan100
desc **Wan Ethernet IP interface Layer 3***
! interface VLAN
ip address 172.19.247.130 255.255.255.128
crypto engine slot 2/0
!
interface Vlan101
desc **Connects multiple switch ports to spa vpn adapter to 1 ip address**
! port VLAN
no ip address
crypto connect vlan 100
interface Tunnel2
description ***mGRE DMVPN Enhanced Ethernet Interface ***
ip address 172.19.254.129 255.255.255.128
no ip redirects
ip mtu 1400
ip flow ingress
ip nhrp authentication xxxxx
ip nhrp map multicast dynamic
ip nhrp network-id 40000
no ip split-horizon eigrp 9
ip tcp adjust-mss 1300
delay 8
tunnel source Vlan100
tunnel mode gre multipoint
tunnel protection ipsec profile gre3
crypto engine slot 2/0
!
