04-20-2005 03:49 AM - edited 02-21-2020 01:43 PM
Dear all.
I currently have a Cisco Pix Firewall and a VPN Concentrator.
I have set up both of these as per the instructions at http://www.cisco.com/en/US/products/hw/vpndevc/ps2284/products_configuration_example09186a00800949d2.shtml
My problem is that i can connect to a host, fine, on the pix side of the VPN from a host on the concentrator, but i cannot see or ping any hosts on the concentrator side of the VPN from a host on the PIX side.
Does anyone know how i can get round this?
Thanks in advance
James
04-20-2005 10:55 PM
Hi James,
if you can establish a connection from a host at the concentrator side to an host at the pix side, then I would think that the vpn connection itself works. Maybe some filter or access-list blocks the traffic (to setup a connection) from the pix to the concnetrator side.
HTH
Mark
04-26-2005 04:35 AM
Unfortunately I haven't set any filters and the only access-lists i have is allow any ip out and the vpn access-list.
Do I need to set some kind of route or access-list??
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide