Email Configuration

[kinggmmm]

Hello,

I want to configure Cisco WSA to Send AN Email to a specific user,

how could I enter the Email configuration on the Appliance?

Hope someone can help me.

Regards

[Ken Stieers]

Emails from the WSA are all alerts or reports.



You can set up alert recipients under System Administration/Alerts

You can set up the SMTP relay under Network/Internal SMTP Relay

And set the return address under System Administration/Return Addresses

You set who a scheduled report goes to when you set up the specific report you are running.



Hope that helps.



Ken

[kinggmmm]

hello Ken

hope you doing well,

I have tried to do the same configuration that you said, but there are no emails.

so where should I enter the email configuration and the sender email or is there any troubleshooting steps to do.

Best Regards

[Ken Stieers]

Those are the only places to do the email config.

Check to make sure the IP its using as a relay will allow the WSA to send mail.



And then I'd start a packet capture for port 25 on the WSA, and then schedule a report to run, or force an alert somehow.

Then stop the packet capture and check it.