Kernel Panic when installing vWSA in Hyper-V

[fw_mon]

Windows 11 with Hyper-V Manager v 10

my steps:

• download coeus-15-2-0-164-S100V.vhdx.tgz Hypervisor Image from Virtuelle Cisco Secure Web Appliance - Cisco
• extract a vhdx image from the tgz archive
• hyper-v manager > New virtual machine
• 3 CPU cores, 8 GB Ram according to the documentation
• short after start I get a kernel panic message and the VM restarts.

does anybody else have this issue?

[balaji.bandi]

never tried on Windows 11 :

check the requirement.

https://www.cisco.com/c/en/us/td/docs/security/wsa/wsa-va-install-guide/virtual-appliance-install-guide/m-system-requirements.html#hardware-requirements-for-microsoft-hyperv-deployments

[fw_mon]

the reqs are met, Win 11 with Hyper-V v 10, vWSA 15.2

[amojarra]

@fw_mon 

can you please confirm the secure boot is disabled + you are using Gen 2 ?

Regards,

Amirhossein Mojarrad

+++++++++++++++++++++++++++++++++++++++++++++++++++

++++     If you find this answer helpful, please rate it as such    ++++

+++++++++++++++++++++++++++++++++++++++++++++++++++

[fw_mon]

@amojarra I use generation 1

[fw_mon]

Can someone with Hyper-V available try to start a Hyper-V image here Software Download - Cisco Systems ? You don’t even need a license - the kernel panic appears within the first few seconds of the initial attempt to start an image.

thank you

[amojarra]

Thank you @fw_mon 

I've tried with Hyper-V server 2019 and 2022 versions 14.5.1-008 and 14.5.1-016 last week with Gen2 VM they were OK, I will try to check 15.2 as well if my LAB is still up. 

meanwhile may I ask to please share the Kernel panic Error ? 

Regards,

Amirhossein Mojarrad

+++++++++++++++++++++++++++++++++++++++++++++++++++

++++     If you find this answer helpful, please rate it as such    ++++

+++++++++++++++++++++++++++++++++++++++++++++++++++

[fw_mon]

Hi @amojarra 

screenshots are attached. The VM starts only when configured as a Generation 1 VM. With Generation 2 I got another error (also attached).

I got this when configured Generation 2 (just wanted to test after you mentioned that Gen2 works for you):

the order of screenshot reversed (read them from the bottom up).