RRM - where to tune with site survey settings?

[patricianet]

Where do I tune the RRM based on site survey software settings? 

In the site planner report shows: (How would I tune RRM to these settings?)

Coverage Requirement: Voice + Data

Signal Strength Min	-67.0 dBm
Signal-to-noise Ratio Min	20.0 dB
Data rate Min	20 Mbps
Number of Access Points Min	2 at min. -75.0 dBm

Channel Overlap Max	2 at min. -85.0 dBm
Round Trip Time (RTT) Max	200ms
Packet Loss Max	2.0 %

[Scott Fella · Accepted solution]

There is no magic button to “tune RRM”. The planner software is a predictive survey design based on what you have input into the software. To tune RRM, you have to test and validate areas and see what you want to improve on. Planning software is just that a planning tool in hope that when you have installed your AP’s, that RRM will work fine.