Cisco Prime Infrastructure Client and User Data to Syslog
I have a question that i'm hoping someone will know the answer to. Below is a screen shot of the Clients and Users tab in Cisco Prime.
Currently we have a 7 day retention period for disassociate clients and a 32 day on associated clients. I would like this data sent to our Splunk deployment so that i don't have to up the retention period on Prime but can still retain this client data for a longer period of time.
Specifically we would like to retain MAC/ IP/ AP IP / Location at a site where the user was connected. IF there is more data that is fine as well but in particular would like those things.
Is there a way to do this?
Clients and Users - Prime 3.1
If this is not possible is there a Syslog level that I can set specifically on the WLC's that they can send those data points to Splunk?
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 184.108.40.206, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...
Hey Guys,I Have several 1600 Series AP's (AIR-CAP1602I-ZK9) that was working with WLC before, I changed them with 1800 series but would like to use 1600 Access Points series independently and without WLC for somewhere else, so I want to know do they...