Clients will not connect to 1231G AP

[Chris Johnson]

Hey guys, I bought 3 of the Aironet 1231g access points and cannot get any clients to connect to them.  I have tried everything from an Iphone, Droid2, Win 7 and XP laptops with built in wireless G cards. All say that they cannot connect to the wireless network. I have two setup currently, one on Vlan 1 that I have configured the way I want with WPA2 enterprise. The other one is just one I setup while playing around.

[Surendra BG · Accepted solution]

Config Looks messed up!! Please change the same like below..

dot11 ssid 2BCMember

   vlan 2

   authentication open

   no guest-mode

   mbssid guest-mode

   no mobility network-id 2

   authentication key-management wpa

   wpa-psk ascii 7 070224414C0C0B5547

!

dot11 ssid 2BCOffice

   vlan 1

   authentication open eap eap_methods

   authentication network-eap eap_methods

   authentication key-management wpa

   mbssid guest-mode

   no infrastructure-ssid optional

   no mobility network-id 1

!

!

!

!

!

!

interface Dot11Radio0

no ip address

no ip route-cache

!

encryption vlan 1 mode ciphers aes-ccm

!

encryption vlan 2 mode ciphers aes-ccm

Lemme know if this helps and please dont forget to rate the usefull posts!!

Regards

Surendra

[Chris Johnson]

So I'm only changing the parts mentioned in your reply, correct?

[Surendra BG]

yes please!!

Regards

Surendra

[Chris Johnson]

Sorry for being late getting back to you on this, it worked! I have gone through the setup from scratch now from the beginning and I think I just tried too much getting it to work, that I just messed it up more. Thanks!