AIR-CAP3602I-N-K9 factory reset fail

[jacob.mmchan]

Dear Wireless Experts,

I had tried to make the factory reset a AP (AIR-CAP3602I-N-K9) and I pressed over the time on MODE button.

Now, I boot the AP every time and the console is only showed as Ranma. Any idea to reset it back to normally?

[yuktunfong]

Check Baud Rate.

&

Try change the Flow Control setting.

e.g. XON/XOFF

[jacob.mmchan]

I connected the Console to the other same of model AP, that is normal

[jacob.mmchan]

I changed the Xon/Xoff  Flow control to be NONE, that is not for this AP also

[jacob.mmchan]

Finally, I got the issued AP, that was showing up Blinking red and blue > Flash file system failure.
How to fix it on Flash file system failure's AP?

[marce1000]

 - FYI : https://wifiworkshop.com/2017/11/28/how-to-recover-cisco-3600-series-ap-with-flash-file-system-error-blinking-blue-and-red/

 M.

[jacob.mmchan]

couldn't access your link ...

[muthomi-nicholas]

I have a similar issue, did you get a solution?