04-06-2015 08:24 AM
Pre-Sales support advised that the 702i will operate as a stand alone AP in autonomous mode. When I purchased the device it came with instruction for setting up the device but only in a controller based configuration. I see the mode button on the device but the documentation says it will do a factory reset for only Autonomous mode AP's.
I called for support but the support rep said the device does not qualify for technical support, only hardware support or replacement. I find it hard to believe Cisco is selling a product but not providing documentation on how to fully configure the device and then saying over the phone they will not help with a configuration questions.
How do I get the device into Autonomous mode?
04-06-2015 08:44 AM
My name Eric Moyers. I am an Engineer in the Small Business Support Center.
I am sorry to hear that you are experiencing this issue.
I am very sorry for the disconnect between you and the Presales Rep that you spoke with. The CAP702I is, as you have found out, truly controller based. I am not sure, but I feel that maybe the Sales Rep was referring to the SAP720i, the difference be as I am sure that you can tell is the C and the S one meaning Controller and the other Stand Alone. I hope that this clears up the misunderstanding. I would check with the vendor you purchased it from, they should be willing to swap it out for you.
Eric Moyers
.:|:.:|:. CISCO | Cisco Presales Technical Support | Wireless Subject Matter Expert
Please rate helpful Posts and Let others know when your Question has been answered.
04-07-2015 04:07 AM
Please refer:
https://supportforums.cisco.com/discussion/12382041/air-cap702i-e-k9-autonomous-ios-problem
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide