Lan port enabling in Cisco 1815W Access point

[amalmichaelvj]

Hello Cisco,

We have a cisco Lan controller 2504 with 38 access points.I have a Cisco 1815W AP with 4 Lan ports.

I need to enable these LAN ports. Lan port should be same member in WLAN.

How can i do it.

Any documents??

[Martin Aleksandrov]

Hello,

Here are the CLI commands to enable the ports:

(Cisco Controller)> config ap lan <enable/disable>

(Cisco Controller)> show ap lan

(Cisco Controller)> show ap lan port-summary

You may also consider addressing this query to Cisco Wireless Mobility community space at : https://community.cisco.com/t5/wireless-mobility/ct-p/4931-wireless-mobility

Regards,

Martin

[amalmichaelvj]

Hello Martin,

(Cisco Controller)> config ap lan <enable/disable> command not available in WLC 2504.

Instead "config ap lan enable access vlan 1 1 AP700F.6AC5.5D30"

AP700F.6AC5.5D30 is Cisco 1815W Ap name

Vlan is default 1

Port is Default 1

But i am getting error logs

"This Cisco AP does not support this feature.".

We need Cisco 1815W enable 4 lan ports in default VLAN 1.

Please help on this

[amalmichaelvj]

Anyone have previous experience in this scenario??

[andauason]

Hi!

I had the same issues with my 1815W. I could find no answers in the community, so I googled it. Here is the solution:

https://www.cisco.com/c/en/us/support/docs/wireless/aironet-1810w-series-access-points/200630-AP1810W-LAN-Port-Mapping.html

However, after the setup, I can connect to the AP either wireless or wired. They cannot work simultaneously. Maybe somebody tries it out and gives better solutions.