Need help to setup a 1602i Cisco aironet

[ahmed-2015]

I recently got an 1602i-K9 access point and I can not enter a configuration part :

 * I do not have the static address management so I cann't use web browser 
 * When I plug my 1602 AP on a dhcp server, the bvi interface takes an IP address,  I cann't enter telnet and I cann't ping this IP adress
 * and when I use the console mode,I can acces the devise, get the enable mode but the command configure terminal does not work

Any help regarding the configuration of this device please ??

[ahmed-2015]

Hi,

Always in the same subject, 

Show version result : Version 15.2(4)JA1  

Commande Configure terminal doesn't work, may I upgrade device ? 

Thank you

[Moin Ilyas]

Could you please let us know if you would use it as Controller Based or Standalone Mode?

[rcarlin99]

I am trying to use 1602i as standalone.