Wireless - Small Business

Hello, I'm trying to set up my Guest WiFi VAP on my Cisco WAP561 so that it only allows guest users to access the internet and none of the local services.  The network topography is simple; Internet -> Netgear Cable Gateway/Router -> TPLink PoE Injec...

I recently got an 1602i-K9 access point and I can not enter a configuration part : * I do not have the static address management so I cann't use web browser  * When I plug my 1602 AP on a dhcp server, the bvi interface takes an IP address,  I cann't ...

So I am having an issue That i think is not easy to solve.  I have a brand new out of the box AIR-CAP2602i-A-K9.  ...and thats all I have! lol i do not have controllers nor any other cisco equipment. (Except some security device but i dont think its ...

What is the default IP address for AIR-CAP1602I-A-K9.  I am trying to install this as a standalone device. It is not getting an IP from DHCP Thanks

Bought an used SRP547W off ebay then realised that the unit is locked at service provider default.I only got the user level login and password.Is there a way to recover the admin account and password?I think I need the admin account to reset the conf...

Dear Cisco support;We need SSH/Telnet feature for command line configure. 

hi all,now i want to filter mac address and ip in my air ap 1242 ag-a-k9 but i cannot show all client accessed my ap .please help how to config it by web interface and cli command,Thank you very much !

Dear SirI have a Cisco WAP4410N and I am not able to access on it ? i mean I am not able to login on it can you help me what is the username and password of that. Regards Nezamuddin Shamsi

I have seven WAP-121 access points deployed at various clients.  Only one is having the issue below.  This has been an issue since the WAP was new. Every time the WAP is power cycled, it resets the time to December 1999.  NTP is on and configured the...

Hello, We were adding Client QoS on the Cisco WAP 371 but interestingly we cannot specify a port range when configuring a class map. Any workaround? Thank you!

Please I need an advice. I have one functional  Cisco WAP4410N where I have configured two separate SSIDs (one for guests). I want to buy second one Cisco WAP4410N and configure it as repeater, where I want to have both SSIDs from the main AP. Will i...

After restoring the WAP321 to default settings over 10 times I still can not access the device on 192.168.1.245It just times out. it wont ping. Is there any way to configure this device other then the default?  Thanks 

I just installed the AEP371 Access Point. It works but the data rate is just 1 Mbps. Any suggestions about what the problem might be? The configuration was straightforward using the Quick Start Guide. .

Hello,Based on recommendations I received from an earlier posting I purchased a WAP561 for an end user client.  The WAP561 is connected to an ESW520 switch that is 802.3af compliant for POE.  The WAP561 unit appears to power up, but it is not getting...