06-28-2018 03:24 PM - edited 03-21-2019 10:51 AM
I installed one RV215W (fw 1.3.0.8) router in my company and after configuring it I realized that It never uses the secondary wireless channel even with 20/40 Mhz is selected in Wireless->Basic Settings-> Wireless band Selection, using WPA with AES encryption, and 802.11 only selected. Tried auto and manual channel selection also.
I tried forcing the N transmission Rate between 65/135 and 130/270 mbps with no luck, even worst because no devices can connect.
Using WiFi Analyzer in my mobile phone I can see only one channel being used.
All my devices are capable 150 Mbps / 300 Mpbs capable and successfully tested with different routers and access points from other vendors.
Any suggestions?
07-10-2018 08:01 AM
Dear Customer,
The issue you have come across might require some further testing. Would be able to open up a support case with us? Here are all Small Business Support numbers: https://www.cisco.com/c/en/us/support/web/tsd-cisco-small-business-support-center-contacts.html
Thank you!
07-10-2018 08:27 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide