03-29-2007 04:11 AM - edited 07-03-2021 01:51 PM
Device WLC 2000( with the new IOS AIR-WLC2006-K9-4-0-206-0.aes) and AP 1130.
First time when i power on AP1130, WLC is able to detect it and wireless is working fine
WLC will automatically upgrade the IOS of 1130AP to c1130-k9w7-tar.123-11.JA1.tar
but once I power off and on the device ,AP1130 will keep rebooting.
WLC cannot see it , it order to make it working again i need to console to AP1130 and erase all the config and ios .
Any idea how to solve this ?
03-05-2018 09:09 PM
Here is the cli shows the ssid's and interfaces etc. but via the webgui there are no ssids listed and it says that both radio's are up, but line protocol is down (while the current ssid's are still broadcasted)
I suspect the gui is corrupted, what may be fixed by a reboot, but currently a lot of users are connected.
I have this in CLI
dot11 ssid wifi-Gasten
vlan 20
authentication open
authentication key-management wpa
mbssid guest-mode
wpa-psk ascii 7 0114140BE455030420420F
The ssid needs to be changed to Gasten but when I do this via CLI, the network doesn't show up anymore in the wireless networks list.
03-08-2018 10:22 PM
Hello Tan,
1130 AP keeps rebooting cannot find WLC
Issue the debug lwapp errors enable and debug pm pki enable commands.The debug pm pki enable command shows the certification validation process that occurs during the join phase on the controller.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide