Hi everyone,
Now I have problem with AP 1832i boot.
Its have a boot log as below :
U-Boot 2012.07 (btldr release 38) (Oct 29 2019 - 06:39:45)
This product contains some software licensed under the
"GNU General Public License, version 2" provided with
ABSOLUTELY NO WARRANTY under the terms of
"GNU General Public License, version 2", available here:
http://www.gnu.org/licenses/old-licenses/gpl-2.0.html
DRAM: 1 GiB
NAND (ONFI): Detected SPANSION S34MS02G2 [256 MiB]
SF: Detected Macronix MX25U3235F [4 MiB]
MFG data loaded
Scanning shenv data blocks
Total valid parts=4
Active shenv part[1:0], write_counter=27
PCI0 Link Intialized
PCI1 Link Intialized
Net:
PHY ID = 0x4dd074, eth0 found AR8033 PHY
PHY ID = 0x4dd074, eth1 found AR8033 PHY
Valid I2C chip addresses: 51 52
AP 1832/1852 detected...
Power Type: Power Brick detected...
Button is pressed. Configuration reset activated..
Keep the button pressed for > 20 seconds for full reset
Wait for the button to be released ....
Button pressed for 23 seconds
Setting env for full reset..
Writing to SPI Flash... done
Signature returns 0
BL signing verification success, continue to run...
Auto boot mode, use bootipq directly
Hit ESC key to stop autoboot: 0
Specified BOOT: part1
UBI error: ubi_io_read: error -74 while reading 112640 bytes from PEB 507:4096, read 55296 bytes
ubi_io_read[188] not here
UBI error: ubi_init: cannot attach mtd2
UBI error: ubi_init: UBI error: cannot initialize UBI, error -74
UBI init error 74
Booting from part1
Error, no UBI device/partition selected!
Error, no UBI device/partition selected!
Booting failed, try boot on part2
Error, no UBI device/partition selected!
Error, no UBI device/partition selected!
(RNAQ-C7) #
I tried to use "tftpboot" command and boot the device by tftp .
Using the "printenv"
(RNAQ-C7) # printenv
bootcmd=bootipq
bootdelay=5
bootfile=part.bin
ethact=eth0
ipaddr=192.168.1.1
machid=1260
mtddevname=fs
mtddevnum=0
partition=nand0,0
serverip=192.168.1.254
stderr=serial
stdin=serial
stdout=serial
Environment size: 224/65532 bytes
But now, I'm still not boot the device.
I focused one point error is "UBI"
UBI error: ubi_io_read: error -74 while reading 112640 bytes from PEB 507:4096, read 55296 bytes
ubi_io_read[188] not here
UBI error: ubi_init: cannot attach mtd2
UBI error: ubi_init: UBI error: cannot initialize UBI, error -74
UBI init error 74
Everyone have solution for this trouble ?
Thank you...
