2.4 GHz. Frequency setting.

[alikoca869453]

There are 11 access points in the system. The distance between them is 80 mt. only the difference between 3 of them 450 mt. 2.4 MHz. Signals between operating devices are low. The current frequency settings are as shown in the picture. how the settings should be.

[alikoca869453]

but I couldn't find the exact value

2.4 Devices have low signal. In fact the problem is simple here which value should I enter.

[alikoca869453]

2.4 Devices have low signal. In fact the problem is simple here which value should I enter.

[patoberli]

You should enter the correct Antenna Gain, based on the attached antenna, minus a possible cable loss (if you use extension cables).
To change/enable DCA you have to temporarily disable the 2.4 GHz network first, enable/change DCA, then enable the 2.4 GHz network again.

I also recommend that you only use the channels 1, 6 and 11 for maximum compatibility.

[Emerson Rodrigues]

Could you please share a screenshot from Wireless>802.11b/g/n>Network.
I want to see data rates

[Leo Laohoo]

Hold on ... ANT2568VG & ANT2513P4M are DUAL-BAND antennas. Are you saying you've got two of these APs connected to the same AP?????