Wireless

Hi,I have access points ( 9120AXI-E model ) registered on 9800-LC wireless lan controller. I would like to enable SSH on the APs and  I am unable to find the option on the WLC, like we have on other models of WLC. Any inputs? Regards,N

I know that AP Group maps the WLAN SSID to Interface for the APs in that group, while Flexconnect Group maps the WLAN SSID to VLAN. However, i have a confusion below.In normal case, if i have a SSID "Office", dynamic interface "Int-office" with IP 17...

I deployed points on remote sites in flexconnect mode with local switching and central authorization, after everything was configured, they began to connect users, there were complaints that the connection takes place from 10-20 times, and debug stop...

Hi,I am using WLC 5500 in the WLAN and I have added 42 AP 1500 and 1800 Indoor which is the amoung limit number of AP supported by my WLC.Can someone suggest any better solutions:* Change AP model by 2800 or another model which can cover large area b...

Hello, I have registering a WLC5520 in the smart licensing portal, generating a token.The first time I didn't add some licenses for the APs, so I added the required amount.But after, in the WLC, the status was not refreshed.So I generated another tok...

Hi SecureCRT and putty can logon to WLC, but the new WLC ver 8.10 cannot be accessed. The below is error message from SecureCRT:Any solutions? Thank  youKey exchange failed.No compatible MAC. The server supports these MACs: hmac-sha2-256,hmac-sha2-51...

I never really configured an AP controller but how do you determine at which point in a building or house the device will move over to the next ap becuase in order for me to get them to change i have disconnect and reconnect

Hi all, I've inherited a site, this is a warehouse setting with various WAPs:AIR-CAP2702E-E-K9AIR-AP1562I-E-K9= x15 WAPsRunning from WLC: AIR-CT2504-K9= x2 WLCs The warehouse mainly uses wireless ATEX mobile phones and wireless bar code scanners. The...

Hi everyone, hope you're safe & healthy. We've had a Wireless network (old SSID) for a couple of years, which users are authenticated via RADIUS (Windows Server 2008). It was working perfectly, but last week suddenly it has stopped doing its job. To ...

cp-8865 bluetooth connection with Cisco Headset 730 NOT allowing me to answer and hang up calls using call button on headset, please help ASAP!!! I bought the 730, everything works ok.. BUT when I connect it via bluetooth to CP-8865, it doesn't let m...

Hi All,I am using the WLC with FlexConnect mode , I have the external DHCP server for assign the IP address to clients (by using  IP helper from SVI interface of Layer3 switch).I'm trying to capture the DHCP message between client and DHCP server and...

Hello I am present some issues with my clients, laptops connect and disconnect from the wireless network sometime i have to disable and enable the wirelless card to conected again, i checked the laptop and enable that the wireless network card is alw...

Hello,We have 2 WLCs 5520 in HA SSO mode.We need to have the CIMC ports configured to be able to sometimes power on/off, reset and so on the devices, via the CIMC https web interface. I have searched but I was not able to find a precise procedure to ...

I am trying to enable TACACS for the web GUI access for a Catalyst 9300 with embedded 9800 controller. ISE is acting as the TACACS server. The switch is running 17.4.1 and the ISE 2.7.0356 (patch 2) I've followed the guides but the switch is sending ...