2504 WLC

[supierz.kamil]

I have a problem with two 2504 controllers. Problem description: WLC1 supports AP AP WLC2 5 AP. Both broadcast the same network. If I move between AP WLC1 to WLC2 AP device connects to the network if it reverts to AP WLC1 then the device connects where it may be a problem

[Rasika Nayanajith]

Pls explain it further,

I did not understand it properly to comment.

Rasika

[supierz.kamil]

I have a problem with two 2504 controllers. Problem description: WLC1 supports AP AP WLC2 5 AP. Both broadcast the same network. If I move between AP WLC1 to WLC2 AP device connects to the network and everything is ok but  if device back to the  to AP WLC1 then the device cant connect. And i must restart the device (laptop, or pc

) 

[Rasika Nayanajith]

Have you configured Mobility between WLC1 and WLC2.

Pls check below post and you will understand how you can configure it via CLI . You can do the same via GUI as well (refer config guide if you like to do it via GUI)

https://mrncciew.com/2013/05/20/mobility-config-via-cli/

"show mobility summary" output verify your peering config.

HTH

Rasika

*** Pls rate all useful responses ***