Hi Folks,
In the past when working with WLCs the interfaces have always been configured as LAG / trunk with the dynamic interfaces/vlans all going through the same LAG.
Can I have say some ports configured in a lag and then the left over physical ports potentially used for a specific dynamic interface? E.G for a dmz
Solved! Go to Solution.
I take that as a separate segment, not you looking in exiting LAG, then you should be able to.
But again it depends on the use case.
personally not implemented never come across this requirement, this is good requirement.
as long that VLAN untagged in LAG, Only Tagged other Port it should work.
here is the reference :