10-28-2008 02:51 PM - edited 07-03-2021 04:41 PM
wlc4402 5.0.148.0 Windows clients have very poor access to network resources inside of our network. The wlan is on a tagged interface associated to a port that is a vlan trunked port on our 6509. If a wlan that is associated to our non-tagged management interface is used, then access is normal. I test this by browsing to internal websites and a websites on one of our dmz's and something like google.
I've put my laptop wired on the same vlan as the wireless wlan to check for basic routing etc.
10-29-2008 07:29 AM
I would upgrade to 5.1 as soon as you can. 5.0 is a dead train. It had a lot of bugs.
10-29-2008 09:15 AM
Thanks for the advice on 5.0. I've got it upgraded to 5.1.151.0 now, but no joy.
10-29-2008 09:17 AM
Do you have an ASA or MARS box doing anything with inspection on the network?
10-29-2008 09:27 AM
The closest i can think of is the websense that our manager uses.
10-29-2008 07:56 PM
So when you are wired you are okay? Do you have more than one dynamic interface on the wlc and if so, do you have issues on all tagged subnets?
10-30-2008 08:18 AM
That's correct. I've put tagged interfaces on both ports and swapped out the sfp's. I'm only having problems if the wlan is put on a tagged interface and with xp and vista. Linux, Mac and even an iphone no problem. Now if i can just convince everybody to switch to a different OS ;)
10-30-2008 12:04 PM
Well you kind of narrowed it down when you said you have no isswues with Linux, Mac and especially iPhones.... Update the driver on the windows client and see if it helps.
10-30-2008 12:48 PM
Good advice on the driver update, I tell all my techs the same when wireless is a problem.
I've done the update route on four different laptops all using different wifi chipsets. One cisco cb21ag, intel 2200BG, Intel3945ABG and i dont remember the others. All w/the latest (thatt i could find)driver downloads
10-30-2008 04:41 PM
Well... that seems to be kind of weird. I know that the 2200's are sometimes of an issue, but the cb21 and 3945 I have not seen an issue with. How is your setup anyways? Are the wlc etherchanneled? The hard part is the fact that some work and some don't. maybe post your show run-config so we can look at if there is a configuration issue or not.
10-31-2008 12:39 PM
11-01-2008 07:13 PM
Well the rest of the show run-config was not there. What I was looking for was the interface and wlan configuration so I have an idea of how you have it setup. One thing is, upgrade the bootloader to 4.2.112.0 ER.aes and then upgrade to 5.0.148.2 BOOT.
Don't know if you want to post the show-run-config without removing the ip address. Just remove the last octet if you are fine with that.
By the way, do you have any dynamic interfaces that are also used for wired subnets?
11-03-2008 11:18 AM
I see what you mean about the run-config. Not too sure what i did there.
We're in the middle of election stuff right now so i'll have to get back tomorrow hopefully.
11-05-2008 11:02 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide