Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I'm involved in a wireless LAN project where we need to provide free Internet access to all passengers in a large airport. We are well on hour way deploying more access points and preparing controller configuration.I would like to here from people wi...

sin by • Level 3
  • 1286 Views
  • 2 replies
  • 0 Helpful votes

Hi,I'm currently trying to upgrade my wcs from version 5.1.64.0 to 6.0.181.0. but every time i run the installation file it tells me that there are multiple copies of the WCS installed on the server and i can't upgrade i can only start a new installa...

Hello,I've recently installed WCS 7.0 on a windows 2003 server and set the time zone on windows to be my local time, UYST which is GMT -2, but when I check on the WCS all times are on GMT not on UYST. Now if I change the time zone on windows to brazi...

gabsfedor by • Frequent Visitor
  • 1366 Views
  • 4 replies
  • 0 Helpful votes

Hi,I am planning to buy a cisco 1260AP so I can connect external antennas.My choice would be the MAST antenna  AIR-ANT2506Do I need to buy 3 antennas?How do I install them on the mast? All 3 antennas on the same mast with the same height?If somebody ...

There are set of 1131G access points which belong to different segment  than management couldn’t be registered on Wireless Controller (Catalyst 6509 WISM). However access points allocated in same range of management network is easily registering on c...

Hi,I have a streng situation.I can ping IP address of WLC and AP from LAN.Also the PC connected through WiFi is responsible but of every one minute is discarded one ICMP packet.This situation is not only to one PC but on others connected to WLAN.When...

wkamil123 by • Level 4
  • 705 Views
  • 1 replies
  • 0 Helpful votes

Hi we have a 5508 series controller, we're using port 1 and 2 with LAG enabled. If I unplug the cable from port 2 anything that relies on DNS starts failing, I'm able to ping based on IP address just not by name. when it's plugged back in it's fine. ...

Ben Duff by • Level 2
  • 753 Views
  • 2 replies
  • 0 Helpful votes

Resolved! 1142 AP in Rommon

/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-parent:""; mso-padding-alt:0cm 5.4pt 0cm 5.4pt; mso-para-margin-...

Has anyone seen or heard of an issue with the internal DHCP server in 6.0.199.4?  We upgraded today and the internal DHCP server on both WiSMs went nuts.  Client address assignment was sporadic, and eventually non-existent.  Client would get associat...

jbrown3118 by • Frequent Visitor
  • 1238 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card