Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
two 5520 in fail-over configurationsoftware version 8.2(2) device manager version 6.2(5)53Creating vpn tunnels to basically identical devices has not worked reliably and im guessing that something is incorrect with the nat(0) statement. So decided t...
wlc4402 5.0.148.0 Windows clients have very poor access to network resources inside of our network. The wlan is on a tagged interface associated to a port that is a vlan trunked port on our 6509. If a wlan that is associated to our non-tagged manag...
I have WCS and 4402 WLC and would like to deploy access points in different builds all controlled from this single WLC. I'd like each building and ap's in the building have their own WLAN/ssid.All the buildings are connected, via fiber to main campu...
I currently have a 7206 w/11 point to point t1's connect via external csu/dsu to serial interfaces on router. Six connections are shared t1 w/voice and data using external Drop and Inserts, the other five are strictly data. The voice channels are c...
I have a telco person wanting to put the management port of their phone switch on to the network in one of our remote offices. They say that it will not handle broadcast very well and it will cause it to reset.So is there a way to limit the broadcas...
Seems like it would be easier to set it up like the old telephone operator did. When someone wants to talk to another, just plug both into the switch, then after a prearranged time limit unplug both then wait for the next request.
Hokay,Here is another attempt at a running config.BTW i've put 4.2 on the wlc and now change.I've also opened a tac call and will post any info i find out.
I see what you mean about the run-config. Not too sure what i did there. We're in the middle of election stuff right now so i'll have to get back tomorrow hopefully.
