04-11-2013 10:48 PM - edited 07-03-2021 11:54 PM
Hello,
In the old days I used two autonomous 1242AG access access points to create a 5GHz PtP link with 2 patch antennas (over small distance 50meters and on on private premises) to connect an small building or garage were there was no ethernet availible. and used the 2.4GHz radio to serve clients in the small building area, worked great.
My questions now are?
Best regards
Joeri
Solved! Go to Solution.
04-12-2013 05:09 AM
Yeah I would put them in bridge mode and if you want to connect a switch, you need to enable Ethernet bridging on the mesh.
http://www.cisco.com/image/gif/paws/111451/indoor-mesh-deploy-guide-00.pdf
http://www.cisco.com/en/US/docs/wireless/controller/7.0/configuration/guide/c70mesh.html
Sent from Cisco Technical Support iPhone App
04-11-2013 10:56 PM
Can I use the same setup with the 2602e access points?
Yes. Just convert the 2600 into autonomous IOS.
04-11-2013 11:16 PM
Yes you can use a controller. You would put both aps I'm bridge mode (mesh).
But if I were you I would go autonomous ..
Sent from Cisco Technical Support iPhone App
04-12-2013 05:09 AM
Yeah I would put them in bridge mode and if you want to connect a switch, you need to enable Ethernet bridging on the mesh.
http://www.cisco.com/image/gif/paws/111451/indoor-mesh-deploy-guide-00.pdf
http://www.cisco.com/en/US/docs/wireless/controller/7.0/configuration/guide/c70mesh.html
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide