Hi,
Our nat table does not time out all the udp rtp traffic from 792x wireless phones. Normal 7940/60 works fine and any other traffic. When the "left" time has counted to zero it goes to "timing-out" state and stays there unless we do manual "clear ip nat trans * "
IOS version 12.4.(11)T4 does not have this problem but never and even 15.x has the same issue. I have tested phone load 1.3.3 and 1.3.4SR2 without a change. I have tested a static and dynamic nat and no effect there. I have tested different wireless access points and no effect. It might be a tac case if anyone else has no ideas.
Does anyone have more information what might cause the problem?
Here is an example what fills the translation table:
sh ip nat trans ver
""""""""""""""""""
udp 172.16.119.248:20064 10.79.191.244:20064 10.76.134.119:26180 10.76.134.119:26180
create 00:22:22, use 00:21:26 timeout:300000, timing-out,
flags:
extended, use_count: 0, entry-id: 103, lc_entries: 0
udp 172.16.119.248:25824 10.79.191.244:25824 10.76.134.119:16528 10.76.134.119:16528
create 00:23:59, use 00:23:57 timeout:300000, timing-out,
flags:
extended, use_count: 0, entry-id: 98, lc_entries: 0
"""""""""""""""""""