cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
316
Views
3
Helpful
2
Replies

9120 broken cli?

Janne K.
Level 1
Level 1

I had an 9120 Accesspoint connected to a 9800 WLC(17.12.4), and did a hard reset on it with the mode button.

It then found my old 8540 WLC (8.10.181.3) it connected fine.

Now I set it to connect to the 9800 again and it does so fine, but the CLI is totally borked and puts out this when booting and having console cable connected..

Is there any way to fix this?

 

1 Accepted Solution

Accepted Solutions

marce1000
VIP
VIP

 

   Ref https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-12/release-notes/rn-17-12-9800.html
    >.... From this release, the default console baud rate of the 802.11AX APs is changed from 9600 bps to 115200 bps.

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

View solution in original post

2 Replies 2

marce1000
VIP
VIP

 

   Ref https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-12/release-notes/rn-17-12-9800.html
    >.... From this release, the default console baud rate of the 802.11AX APs is changed from 9600 bps to 115200 bps.

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

Well... good thing its friday. thanks for the quick help.

Review Cisco Networking for a $25 gift card