9800-40 HA pair, Active unit always in alarm state

[David Ritter]

My c9800-40 pair always shows and Red(Amber) Alarm led on the active unit.  At first I thought it was the stand-by unit but no it be the active unit and toggles between boxes if I trip failover.

There is no such behavior documented .  Documentation would suggest Alarm led sould be stdy green and the HA led green (for hot)

Any idea's.  

[Rasika Nayanajith · Accepted solution]

Does below CLI provide any output

WLC#show facility-alarm status

Regards

Rasika

[David Ritter]

LOL
System Totals Critical: 3 Major: 0 Minor: 0

Source Time
Severity Description [Index]
------ ------
-------- -------------------
xcvr container 0/0/1 Nov 20 2020 09:45:33 CRITICAL
Transceiver Missing - Link Down [1]
xcvr container 0/0/2 Nov 20 2020 09:45:33 CRITICAL
Transceiver Missing - Link Down [1]
xcvr container 0/0/3 Nov 20 2020 09:45:33 CRITICAL
Transceiver Missing - Link Down [1]

Um I only configured 1 port.. why would it complain about the empty,
configured ports
ok, I just placed the 3 in shut status..
.
myWLC#show facility-alarm status
System Totals Critical: 0 Major: 0 Minor: 0

Source Time
Severity Description [Index]
------ ------
-------- -------------------
xcvr container 0/0/1 Nov 30 2020 12:37:35 INFO
Transceiver Missing [0]
xcvr container 0/0/2 Nov 30 2020 12:37:45 INFO
Transceiver Missing [0]
xcvr container 0/0/3 Nov 30 2020 12:37:53 INFO
Transceiver Missing [0]
guess that turned off the led..
Thank you Riska

[Rasika Nayanajith]

Good to hear that David...