cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
382
Views
10
Helpful
4
Replies

9800 feature request: exec mode "ap mac-address" command (like AireOS)

jasonm002
Beginner
Beginner

Everything I can do with exec mode "ap name" commands on the 9800, I should be able to do with "ap mac-address" also. So for example to rename an AP I would currently do:

ap name <old_ap_name> name <new_ap_name>

but I want also to do:

ap mac-address <ap_eth_mac> name <new_ap_name>

 

You can do this on AireOS WLCs using a different command form, for example to rename an AP:

config ap name <new_ap_name> <ap_eth_mac> 

 

I don't seem see anything similar in the command list for 17.6 or 17.7 for the 9800.

 

 

4 Replies 4

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

Reach out to your Cisco Wireless SE/PSS and ask them to raise a "product enhancement request" (PER).

ammahend
Collaborator
Collaborator

don't think you can do "ap mac-address <ap_eth_mac> name <new_ap_name>"  on AirOS , what version you are running ?

(AirOS) >config ap m?
mesh-internal-dhcp mgmtuser migrate mode monitor-mode
(AirOS) >config ap n?
name nsi-ports

 

 

-hope this helps-

I edited the original post to clarify, on AireOS the syntax is different, for example "config ap name <new_ap_name> <ap_eth_mac> "

As Leo recommended you can do a feature request.

-hope this helps-
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers