Hello, recently installed meraki AP , we noticed that a Rogue access point is detected in the Air Marshall section.We can't understand why so many mac addresses are being brodcasted and especially why it is being seen on a specific vlan. The wired ma...
There is Cisco WLC-9800 and one AP is joined to it. My question is that. AP mode: Flex There are two SSID one in Flex and the other in Central. The client can connect to the Flex SSID and can use the internet. When a client connects to Central SSID, ...
Hi,I have a AP discovery case, which boggles my mind, as I wasn't able to find any explanation of it. We have a Infra with 2 SSO pairs of 9800 WLC's serving APs from multiple sites.Next to that, I have a test WLC.There's a mobility configured between...
Hi,we are using Meraki MR-32 and 33 behidn MX-84 to provide some WLANs with. I'm not possible to get a Google TV 4K Working. When it joins the WLAN it says that it has no connection to the internet. Can someone, who has a working google tv, proivde m...
Morning.I have run into a frustrating issue at a client site, where my wireless speeds appear to be capping out at 200mb.The WAN is 800 up/down, and i am seeing these results, on the wired clients (client -> ms210 -> mx68).22 MR44 AP's throughout the...
Has anyone successfully mounted Meraki MR access points to this type of drop ceiling T-rail? https://www.armstrongceilings.com/commercial/en-us/suspension-systems/silhouette-xl-bolt-slot-1-4-grid/item/XL7620.html If so, what mounting bracket did you ...
Hello,I am considering a Cisco Catalyst 9800-L controller to replace our WLC 2504. My question is regarding the End of Life. I can only find information on the End of Life for the IOS XE versions, but not for the controller itself. It is expensive...
Hello Experts,Please help here. I am totally new to the access points. we are small company and we purchased 2 cisco CBW 240AC-D access points and trying to make one of them as primary and another as secondary. but we are not able to see the second p...
What is the benefit of antenna on the MR46E over the MR46. Do the Antenna on MR46E improve range over the MR46?
Hi,I'm looking for battlecards on Fortinet wireless, something on AP's, dashboardThanks
I'd like to configure a CAP-3602E in order to use with a single element grid antenna, as I have several of them laying around.I assume that when I'm in full 4x4 MIMO mode (all antenna ports enabled), if I have Tx power set at 23dBm, each antenna port...
Hi Folks,I got a brand new EWC C9115AXI with no config, attached to a trunk port. The AP MGT VLAN is 200, so I made it as Native VLAN. The SW Version is 16.12.4a.Switch configAP connected port----------------interface GigabitEthernet1/0/7switchport t...
Hey everyone, We've recently deployed a Cisco 9800-40 WLC and are in the process of switching out our 2702 AP's with 9120 AP's. The first few switched out no problem, but we have a growing number of them that are flashing the General Warning diagnos...
Hi wireless professionals, since newer IOS-XE releases it is possible to configure the supported DTLS cipher suites along with a priority. Example ap dtls-ciphersuite priority 0 ECDHE-ECDSA-AES256-GCM-SHA384ap dtls-ciphersuite priority 1 ECDHE-ECDSA-...
Hi everybody,I have a question and would like to be answered. Ap is running OEAP at the branch. I am currently planning a new management ip for AP. If I change the AP's ip on Controller. Can the AP reconnect to the Controller?
