11-07-2020 05:14 AM - edited 07-05-2021 12:46 PM
hey,
I have a small issues with my tp-link AP, I try to connect the ap with a switch 2950 and I can't access the net.
To be clear
->I set on a port the access mode, vlan, switchport security, etc
interface FastEthernet0/10
switchport access vlan 55
switchport mode access
switchport nonegotiate
switchport port-security maximum 6
switchport port-security mac-address sticky
speed 100
duplex full
spanning-tree portfast
spanning-tree bpduguard enable
ip dhcp snooping limit rate 6
what can i do?
Solved! Go to Solution.
11-09-2020 08:49 AM
You are running port-security. Every client attached to the AP might appear as another mac-address and completely filling up the allowed 6 addresses, unless the AP is in router-mode. You might want to disable this.
11-07-2020 06:58 AM
- What do you mean by I can't access the net ?
M.
11-08-2020 10:55 AM
I don't also fully understand your question, but since you have a switch, what if you connect a laptop to a port that is also on vlan 55? You get network connectivity and also access the internet?
11-09-2020 08:49 AM
You are running port-security. Every client attached to the AP might appear as another mac-address and completely filling up the allowed 6 addresses, unless the AP is in router-mode. You might want to disable this.
11-10-2020 03:11 AM
Thank you all the help, I disable the port security and now is working, thanks guys
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide