08-29-2014 02:41 AM - edited 07-05-2021 01:27 AM
Whe have deployed some AP2702i. And I am trying to run traffic on both data ports on the AP.
The POE port is attached to WS-2960S switch and is pulling16,8 Watts, and the AUX port is connected to the same switch and same VLAN. But AUX port is “down” on AP
I have not done any configuration on AP just Default installation. Do I have to config AUX port?
Johan Lindstrand
Solved! Go to Solution.
08-29-2014 03:53 AM
Hi,
AUX port will be disabled if the AP is being powered by a limited 15.4 W .3af PoE source because it requires PoE+, .3at, or local power (wall brick type power supply) to properly function.
Regards
08-29-2014 03:53 AM
Hi,
AUX port will be disabled if the AP is being powered by a limited 15.4 W .3af PoE source because it requires PoE+, .3at, or local power (wall brick type power supply) to properly function.
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide