Good Day, I would like to connect to Cisco's management WLC via wireless. There is a security feature that allows you to ENABLE or DISABLE WLC management via wireless. I have enabled controller management to be accessible from wireless clients i...
We have a Cisco 4400 WLC with about 70 Cisco AIR-1131AG-A-K9 access points. The controller runs and the access points run 4.1.171.0 code. We work in a hospital enviroment and nurses from one of our floors (3N) are complaining about poor/low signal ...
Hi all,Forgive me for not finding it on my own since I am sure it exists. Does anyone have a link to a support chart that shows where support for APs stops on WLC 7.4 code? Specifically, while running APs in Flexconnect mode? Thanks in advance
Hey all,I have a TAC case open, but it doesn't seem to be making any progress....I upgraded my 5508 controller from 7.2.111.3 up to 7.4.100.0Most of my APs are fine. 3500s, 1100s etc.except for 602i APs. The APs associate, they update software etc, b...
Hi,I'm going onsite to look at a 5508 (don't know exact config or code version until I get there) that has stopped displaying the guest authentication splash screen but apparently still allows access. What might cause this? I can open a support case ...
When using Guest Access Cisco recommend a Mobility Anchor Controller be placed on a DMZ and the guest access wireless Lan is tunneled to this controller. This means that 2 DMZ subnetworks are required - one for the management interface and one for t...
I have an access point at a branch office. I have added it to a flexconnect group because I only want the local SSID and the centrally managed guest SSID to be broadcasted. I am not sure how the switch port needs to be configured though. I have a 'gu...
HI Memebers, I have a virtual controller and the AP keeps connecting and disconneting .Number of Traps since last reset 81 Number of Traps since log last viewed 32 LogSystem TimeTrap0Tue Nov 20 19:13:00 2012AP Disassociated. Base Radio MAC:00...
Hi guys,I need a ppt (power point) for Cisco Wireless Lan Controller and WCS. I need to make presentation today. Please help me guys. I already look it over the internet. I didn't find. So, Please help me.BRTotardo
HiI'm seeing a couple of our APs changing channel quite a few times (over 200 in the last 7 days!) and on Cisco Prime Infrastructure it says it was due to signal 100%. Does it mean it is seeing a loss of 100% through interference at times?
Can someone explain to me the purpose of the WLAN controllers?When should one choose to deploy lightweight AP instead of the classic one (1100, 1200).Thanks
Hi,Actually, I work with wlc version 7.2.111.3, I saw some new version, could you suggest to me one if you have already tested it . For the new version IPV6 is required.furthermore, for don't lost all the configuration could you tell me how I can mak...
We are going to purchase new wireless equipments.Now I have 2 questions about Wireless Technology.1) If vWLC was down. Are 3 AccessPoint still working without controller?2) I can't understand FlexConnect clearly. Is there any help in this situation?I...
