Activating HTTPS in Cisco MSE

[tumbl3w33d]

I am working remotely on a new install of MSE 8.0.130.0. The initial setup apparently did not activate it so the only access I have is via Putty. I am not a Linux guy so can someone tell me the CLI command to turn on HTTPS so I can get to the dashboards?

[mohanak]

By default, HTTPS is enabled in MSE,

You can verify the mobility services engine software state at any time. In the mobility services engine CLI interface, enter: /etc/init.d/msed status

Refer link : http://www.cisco.com/c/en/us/td/docs/wireless/mse/3350/quick/guide/mse_qsg/mse_qsgmain.html