Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hi The Controller AIR CT5760-100-K9 by default it support 100 licenses if i need more licences for exmaple if need 9 licences if i upload the licences of 9 APS After  uploading  licenses file then we cannot the controller mgmt ip add   please kindly ...

Hi,I have two 4500x in VSS, in the first Cat4500x there is the WLC Primary and in the second Cat4500x there is the WLC-HA.Both WLC must be on the same etherchannel or can be in a different ethernchannel?Regards..Mirko Severi.

severi by Level 3
  • 2775 Views
  • 6 replies
  • 0 Helpful votes

Hi, My cisco 5508 does not boot. At startup I am getting the following:CF Bus 0 (IDE): OKIDE device 0: - Model: SM223En-AA Firm: SM223EAA Ser#: (03)5526888-2008**** - Type: Hard Disk - Capacity: 31.9 MB = 0.0 GB (65520 x 512)Press <ESC> now to access...

newfabcom by Level 1
  • 2968 Views
  • 9 replies
  • 0 Helpful votes

Dear Experts, I have configured Cisco WLC 2504 version 8.1.102 with 6 access points and have 4 SSIDs. All access points are already joined with controller. Only 3 access point are work properly,however 3 access point work not correct. The issue is th...

We currently have a 5508 running in prod, licensed for 50 AP's.   I also have another 5508 as a spare that I would like to setup in HA config. It is currently licensed for 25 AP's.   Can I use this as an HA secondary or does it also need to have a 50...

dclee by Level 5
  • 654 Views
  • 1 replies
  • 0 Helpful votes

I was hoping someone could explain to me the different SmartNet options for the Mobility Express Bundles.  Last April I purchased a AIR-AP1702i-A-WLC bundle, which if you're not familiar includes 2ea 1700 AP's and 1ea 2504 WLC with a 25 AP license.  ...

loud72 by Community Member
  • 1017 Views
  • 4 replies
  • 0 Helpful votes

What is the time frame for the below "Usage" statistic?  Is it since last reboot of AP, last reboot of the WLC, or just the entire history of the device being associated with the controller? Thanks!

0rsnaric by Level 4
  • 337 Views
  • 0 replies
  • 0 Helpful votes

I know we have to use the App to prime our APs, but we are located in Faroe Islands (FO) and the app dosnt seems to support this. How do we proceed from here? Best regards Jesper

jebi by Community Member
  • 1477 Views
  • 4 replies
  • 0 Helpful votes

Hello, I have an issue to add my license extension (5APs) in a WLC HA cluster! I really don't know how I can do this in CLI (GUI isn't reachable)! WLC1 (pri) ------------------------- WLC2 (sec)                      WLC Cluster IP I have tried to add...

Gura24 by Level 4
  • 2198 Views
  • 5 replies
  • 0 Helpful votes

We have 4 controllers running on our network - three 4400 series & one 5508 model. The 4400 controllers are on Software Version 7.0.250.0 The 5508 controller is on 8.0.120.0 and Field Recovery Image Version for this is 6.0.182.0 Could someone please ...

Review Cisco Networking for a $25 gift card